Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in San Leandro, CA
Gate access control repair in San Leandro typically costs $280-$650 for keypad or card reader troubleshooting, while welding and hinge replacement on salt-corroded iron gates runs $180-$520 depending on whether the concrete pilaster underneath has shifted. We handle both from our Bay Area office, with crews in San Leandro daily. Call (510) 726-7050 for a written estimate before any work starts.
San Leandro’s flatland tracts, especially around Washington Manor and the Halcyon area, sit on Bay mud soils that heave seasonally and marine layer fog that corrodes hardware faster than inland East Bay cities. Most gate problems here aren’t just a broken part; they’re a part failing because the post or pilaster it mounts to has drifted out of plumb. We see this pairing so often that our technicians travel with both welding gear and post-leveling equipment on every San Leandro call.
Why San Leandro Homes Are Different
San Leandro’s housing stock is dominated by 1950s-1970s single-family tract homes, many with original ornamental wrought iron swing gates on concrete block pilasters now 50-70 years old. The westside neighborhoods, particularly Washington Manor, were built on filled Bay mud that continues to consolidate and shift, causing those pilasters to lean forward into the driveway opening over decades. A gate can look broken when it’s actually hanging from a post that is no longer vertical.
The city’s direct San Francisco Bay exposure, anchored by the San Leandro Marina, delivers heavier salt-laden marine layer than Castro Valley or San Lorenzo just inland. Ferrous hinges, latches, and motor housings corrode noticeably faster here. We routinely find gates that need rust remediation on the hardware and post stabilization underneath before any latch or motor adjustment will hold long-term.
The industrial corridor near Davis Street and the BART stations adds a separate demand for heavy-duty rolling and slide gates on commercial properties, but even those systems face the same accelerated corrosion from Bay fog.
Our Main San Leandro Services
San Leandro homeowners call us most often for gate repair, new gate installation, and motor or opener service. Each has its own dedicated page with full pricing and local details.
Gate Repair in San Leandro
We repair swing gates, slide gates, and rolling gates throughout San Leandro’s residential neighborhoods and commercial corridors, addressing the paired problems of hardware corrosion and post drift that define this market. Every repair includes a written price before work starts and a photo record of what was found and fixed. Gate Repair in San Leandro
Gate Installation in San Leandro
New gate installation in San Leandro requires planning for soil conditions and salt exposure from the start. We measure, specify corrosion-resistant hardware, and provide a written fixed price before ordering materials. Installations are scheduled, not same-day, with a free measure and written quote first. Gate Installation in San Leandro
Gate Motor & Opener in San Leandro
Gate motor and opener service covers nine automation brands including LiftMaster and FAAC, with repairs and replacements available for residential and light commercial systems. We diagnose the motor, the control board, and the safety devices, then quote a flat price in writing before any work begins. Gate Motor & Opener in San Leandro
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in San Leandro
San Leandro’s 1950s-1970s housing stock was built before automated access control, so most residential installations are retrofits onto existing iron gates with concrete block pilasters that have shifted over decades. We install and repair keypads, card readers, phone entry systems, and video intercoms, with every job governed by The Haven Standard: written price before work starts, documented photo record on every visit, and our 365-Day Done Right Promise. Gate Access Control systems here face the added challenge of mounting to pilasters that may no longer be plumb, requiring structural assessment before any device installation.
Keypad Entry
Signs you need it
Your current keypad doesn’t respond to code entry, shows moisture damage inside the housing, or was mounted to a pilaster that has leaned enough to crack the back plate.
What it costs in San Leandro
Keypad entry repair or replacement typically runs $280-$450, with new installations on existing low-voltage wiring starting around $380-$650.
How we do it
We test voltage at the keypad location, assess whether the mounting surface is plumb and stable, install or replace the unit with weather-sealed hardware suited to marine-layer exposure, program codes, and photograph the wiring diagram and final settings before leaving.
Video Intercom
Signs you need it
You can’t verify visitors before opening the gate, your existing intercom has no video or the image has degraded, or you’re managing a multi-unit property where voice-only systems create security gaps.
What it costs in San Leandro
Video intercom repair starts around $320-$480; new installations with gate release integration typically range $580-$1,200 depending on cable run length and whether the existing pilaster can support the camera mount.
How we do it
We run or test Cat5e/Cat6 cable from gate to residence, mount and aim the camera to avoid direct marine-layer glare, integrate the gate release relay, test with the homeowner at the indoor monitor, and document the channel settings and wiring path in the job record.
What Gate Access Control Costs in San Leandro
| Item | Typical range in San Leandro |
|---|---|
| Keypad entry repair/replacement | $280 - $450 |
| Keypad entry new installation | $380 - $650 |
| Video intercom repair | $320 - $480 |
| Video intercom new installation | $580 - $1,200 |
Can you add access control to an old iron gate in San Leandro?
Yes, most 1950s-1970s ornamental iron gates accept access control retrofits if the pilaster is structurally sound. We assess post plumb and stability first, then specify hardware that fits the existing gate geometry. Call (510) 726-7050 for a free evaluation and written estimate.
Does salt fog damage access control electronics?
Marine layer corrosion is the leading cause of keypad and intercom failure in San Leandro’s westside neighborhoods. We specify IP-rated housings and sealed conduit connections as standard on every installation near the Bay.
Gate Parts & Welding in San Leandro
San Leandro’s salt-laden marine layer and shifting Bay mud soils destroy gate hardware from two directions at once: corrosion weakens hinges, latches, and frames while soil movement stresses the welds and mounting points that hold them. We replace and weld gate parts throughout Washington Manor, the Halcyon area, and commercial corridors near Davis Street, with every repair leaving a documented photo record under The Haven Standard. Gate Parts & Welding work here almost always requires assessing the pilaster or post underneath before any hardware replacement will last.
Hinge Replacement
Signs you need it
The gate sags, binds, or scrapes the ground; hinges are visibly rusted through or the pin has elongated the barrel; or the gate has been forced open against a shifted pilaster, bending the hinge strap.
What it costs in San Leandro
Hinge replacement on a standard residential swing gate runs $180-$340 for the pair, including removal of corroded hardware and installation of corrosion-resistant replacements.
How we do it
We support the gate with a temporary brace, cut off rust-fused hinges with an angle grinder, clean the mounting surface to bare metal, weld or bolt new heavy-duty hinges with stainless or zinc-plated hardware, adjust gate swing for plumb, and photograph the finished alignment and part numbers.
Post Replacement
Signs you need it
The concrete block pilaster has leaned more than 3 inches out of plumb, shows cracking through the core, or the gate has pulled loose from anchors that no longer bite solid material.
What it costs in San Leandro
Post or pilaster stabilization starts around $420-$680; full post replacement with new concrete footing typically runs $780-$1,400 depending on gate weight and soil conditions.
How we do it
We remove the gate entirely, shore or demolish the failed pilaster, excavate to stable soil or specified depth, pour new concrete with embedded anchor bolts rated for the gate load, cure per code, reinstall and plumb the gate, and document the footing depth and anchor specification in the job record.
What Gate Parts & Welding Costs in San Leandro
| Item | Typical range in San Leandro |
|---|---|
| Hinge replacement (pair) | $180 - $340 |
| Post/pilaster stabilization | $420 - $680 |
| Full post replacement with footing | $780 - $1,400 |
Can you weld a rusted iron gate in San Leandro?
Yes, we weld and reinforce rusted wrought iron frames on-site, but we also identify why the rust accelerated and whether the mounting post is still stable. The weld won’t last if the structure underneath continues to drift. Call (510) 726-7050 for a free inspection and written repair scope.
Why do San Leandro gates need new hinges so often?
Marine layer salt fog penetrates standard steel hinge barrels faster here than inland, and Bay mud soil movement forces hinges to work at angles they weren’t designed for. We specify sealed, corrosion-resistant hinges and check post plumb as part of every hinge replacement.
Brands We Service in San Leandro
We repair and maintain nine major gate automation brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Our San Leandro crews stock common parts for same-day repair on LiftMaster and FAAC systems; other brands typically require one business day for parts pull from our Bay Area inventory. our brands
Pricing for Gate Repair in San Leandro, CA
| Service | Typical range in San Leandro |
|---|---|
| Hinge replacement (pair) | $180 - $340 |
| Keypad entry repair/replacement | $280 - $450 |
| Video intercom repair | $320 - $480 |
| Keypad entry new installation | $380 - $650 |
| Post/pilaster stabilization | $420 - $680 |
| Video intercom new installation | $580 - $1,200 |
| Full post replacement with footing | $780 - $1,400 |
Prices in San Leandro run higher than inland East Bay when post stabilization or rust remediation is required alongside the primary repair, which is common on westside properties near the Bay. Every price is written and agreed before any work starts, under Haven Standard Clause 1; you’ll never receive an invoice larger than the quote you approved.
Neighborhoods We Serve in San Leandro
Our crews are in San Leandro daily, with same-day availability for most repair calls across the city’s residential and commercial areas. Response time is typically under two hours for urgent gate failures during business hours.
- Washington Manor
- Halcyon / Halcyon-Foothill
- Bay-O-Vista
- Estudillo Estates
- Davis Street corridor / industrial zone
Service Area - Cities Near San Leandro
We dispatch to Oakland, CA, Alameda, CA, Walnut Creek, CA, and Berkeley, CA from our Bay Area office, with scheduling coordinated across the full service region. San Leandro homeowners are never routed through a distant call center; a live person answers at every hour and dispatches the nearest available crew.
Serving San Leandro, CA - Our Local Coverage Area
We’re based in the San Leandro area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in San Leandro
We typically dispatch same-day for urgent gate failures in San Leandro, with most calls reached within two hours during business hours and emergency response overnight. A live person answers (510) 726-7050 at every hour to coordinate the nearest crew.
Gate repair on existing posts generally does not require a permit; new gate installation or post replacement may trigger San Leandro building department review depending on height and location. We handle permit determination as part of our free estimate and include any required fees in the written quote.
Yes, we repair and maintain HOA and multi-unit access control systems throughout San Leandro, including video intercom and card reader systems. We provide written scopes and flat pricing for board approval, with documentation that satisfies most HOA management companies.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What San Leandro Customers Say
"The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B.